Bathroom tiles are important decorative materials for the wall and floor of the bathroom decoration, occupying a very important position. The effect of a good tile decoration will be different, and the service life will be longer; if the tile has problems during installation, the quality of the entire bathroom will also decrease. Today, Xiaobian will introduce you to the installation method of bathroom tiles.
If the tile does not soak the water, it will take away the moisture in the cement mortar, reduce its strength, and reduce the adhesion of the tile and the wall. After a long time, the tile is hollow and falling off.
Pay attention to the gap between the tile and the compactness of the cement mortar when paving.
It is normal for the empty drum rate of the tile to be less than 5% of the entire wall surface.
Pay attention to the selection of high-quality tiles when purchasing, which is the premise to ensure the quality of tile paving. Because during the construction process, the construction personnel may raise the error of the flatness of the wall surface, some measures need to be taken to fill the gap separately. If it is necessary to increase some scattered expenses, the consumer should provide support and cooperation as much as possible according to the situation.
The so-called tile draught is to put the tiles in the water for a period of time in advance, usually in about 2 hours, the actual operation can be based on the specific degree of the specificity of the tile.
Before laying the tiles, pay attention to the tiles to be well immersed in water, so that the tiles are fully hydrated, in order to avoid the empty and falling of the tiles.
The traditional method of tile paving is to use cement mortar for paving.
First of all, the proportion of cement mortar should be reasonable. The general practice is that the volume ratio between the two is 1:1. If in this case, the tiles are still empty, except for the technical level of the workers in the paving process, the main reason is that the tiles are not enough in the early stage.
This is done to ensure that the moisture in the cement mortar will not be snatched away by the tile after the tile is applied to the wall, so as to achieve its highest strength, so as to prevent the tile from falling and falling off, which is the most important reason for the tile to soak.
Ball Valve Series,Three-Way Valve,One Piece Ball Valve,Heavy Threaded Valve
Wenzhou KAIZHENG Valve Technology Co.,LTD. , https://www.kazevvalve.com