Many friends came to me and asked why the shower room in our house was so slow, and it was always blocked. The number of explanations was much higher. I felt that it was necessary to write a popular science for everyone. I hope everyone can renovate the new house and renovate the old house. I can get a more satisfactory shower room.
The design of the shower room floor is a big thing related to the quality of the bath. Many friends will always have water when they take a bath. If the water in the shower room is not smooth, it will spill on the feet, so many people will choose to drain the shower room. Open, so that although the water is getting faster, the ensuing is the blockage. The feeling of the water on the feet is not open, and it is too much trouble to clean up the water. It is expected that many friends will have a deep understanding. Then we will analyze the design methods, advantages and disadvantages of several common shower rooms today, and hope to give you some inspiration. Stone Learning Society ID: stone5A
Case number one
The above is the design of our common shower room. The advantage of this design is that the requirements for hydropower and mason masters are not high, and the size is casual. The defect is because the tile is laid, the ground around the floor drain will not have too much slope, and the water below will be slower. When it is actually used, when the water is always open or the foam is particularly high, you will find that the water is flowing to the foot. On the other hand, it is quite disgusting that the dirt appears along with the water waves, and the blockage caused by opening the floor drain is even more difficult to deal with.
Case 2
The shower room in the picture above can't see anything wrong with it, but in fact it is still a shower room that can "bub feet while taking a bath". The location of the launching water is opposite the showerhead, and the water flow to the right is slow due to the massive accumulation of water on the left side. If you use this design, please be sure to put the floor drain on the same side of the shower.
Case three
Because many people are worried about the problem of slow water, some people often design the shower room as the above picture. This design is a common design method in the hotel. The middle part of the marble is raised and recessed. The design benefit of this shower room is that the probability of water getting wet to the foot is very small unless your sewage is heavily blocked. However, the design of such a shower room has certain limitations. First, it requires the bathroom to be rectangular, or the area is particularly large, which becomes an obstacle if it encounters a special shape. For example, the following situation.
Or our common diamond shape, it is quite difficult to design a four-sided concave.
How do we design
Taking into account the various situations mentioned earlier, we made an improvement to the existing case of excellent drainage when designing the shower room. This method can be applied to shower rooms of any shape. Not only the drainage is placed on the same side of the shower, but the entire shower room (from the floor drain to the other side) has a slope of 1 CM. This slope does not cause discomfort and speeds up the launch. Not only that, but we also made a thickness of about a marble in the ground drain position, so that the water flow first into the sinking groove, so that even if the ground drain is not fast enough, it will not cause water to overflow onto the foot. . And a lot of water will increase the water pressure in the groove, increase the pressure of the water, and speed up the water flow.
Does such a drainage system feel more reasonable? Is it difficult to make such a drainage system? Frankly speaking, it is a bit difficult. This has certain requirements for the renovation of the drainage pipe of the shower room, from the pre-design to the later construction. Connected to the position. First of all, in the hydropower stage, when placing the floor drain and drainage, it is necessary to reserve 11CM space near the wall. In addition to increasing the wall tile center point is about 8CM away from the wall, so that the concave marble is 16cm wide, the advantage of this width is that When you take a bath, you won't step in (adults), and you won't overflow when a large flow of water passes. When laying the tiles, the mason must keep a slope of 1cm, which can ensure the smooth flow of water. Do this well, you don't have to worry about the slowdown in your shower room. Stone Learning Society ID: stone5A
As shown in the figure below: the concave part is at the shower faucet. This design may be used in any shape of shower room, not subject to area control, quick water, easy to clean, and good foot feel.
In the design of home decoration, the design of small details often has a very big impact on the future use, especially in the shower room, which must be touched every day. Good design and construction can be used more worry-free and comfortable.
Ultraviolet Germicidal Bulb,Portable Uv Lamp,Uv Light Bulbs For Humans,Nb Uvb Lamp
Guangdong Kingrate Optoelectronic Technology Co., Ltd. , https://www.kingrateuv.com