How to make fire prevention measures in the high temperature environment in the enterprise factory

I. Institutional measures
1, fire responsibility system
Under the premise that the legal representative or the chief person in charge is fully responsible for the fire safety management of the unit, the fire safety responsibility system shall be implemented step by step.踩 腊 踩 踩 踩 稹 稹 稹 ? ? ? ? ? ? ? ? ? ? ? ? ǜ骷 ǜ骷 ǜ骷 ǜ骷 踩 踩 踩 踩 踩 踩 踩 踩 踩 踩 踩 踩 鹑 鹑 炯 1 . 1 1 1 . . . . . 1.牟悴愀涸鸬How to use the open flame approval system
The use of open flames in fire- and explosion-hazardous locations must be handled by the fire-fighting and technical security departments before the large units can go through the approval procedures and the approval of the relevant departments. Firefighting and technical security departments must send people to the scene for monitoring. The firefighting department should send fire engines to the worksite in case of emergency.
3, fire inspection system
Fire safety key units shall carry out daily fire inspections, and they shall be able to carry out daily fire inspections. They shall use the fire and electricity for any violations. Happening;
(2) Safety exits. Whether the evacuation channel is unimpeded, safety evacuation prompt signs, and emergency lighting equipment are in good condition;
(3) Fire-fighting equipment , equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, equipment, etc.; (4) whether the normally closed fire door is closed, whether the stacked objects under the fire shutter affect the use;
(5) Personnel in post at key positions in fire safety;
(6) Run, blow, drip and leak of flammable and explosive facilities;
(7) Other security conditions.
1. There is a full-time fire brigade with sufficient firefighters.
2. Equipped with necessary fire-fighting facilities to keep the factory's fire-fighting facilities in a normal and effective operating condition.
3. The regular inspection system for fire protection facilities is well aware of the completeness and performance of the equipment.
Technical precautions
The following measures can be taken to control and eliminate sources of ignition:
1. Strict management of all kinds of naked fires Establish fire-fighting areas around fire and explosion hazards in factories, establish a clear fire-fighting sign, and strictly prohibit smoking in fire-fighting areas: Establish a sound fire-fighting management system and implement a fire-fighting examination and approval system for dangerous places. System 2. Controlling the generation of frictional sparks to avoid sparks due to friction and impact in the operation of machinery and equipment. For this reason, it is required that the operating part of machinery and equipment be kept lubricated. 3. The generation of electrical sparks should be prevented. Plants should be classified according to the grade and substance of the fire hazard location. The electrical power equipment, instrumentation, electrical lines and lighting devices in the workshop are respectively protected against explosions, closures and isolations: periodical overhaul of electrical equipment and lines.
4, to prevent static electricity, on the other hand, when the electrical leakage occurs, can play an effective role in protection: transport flammables, it is necessary to control the flow rate of the conveyor belt, but also reduce the classic important measures.