First of all, we understand the composition of the artificial turf. Artificial turf composition: plastic grass, lawn bottom, non-woven fabrics, seams cloth paste. Its paste precautions are as follows:
Before the paste, ensure that the surface of the non-woven fabric, seam cloth, and the bottom of the lawn is clean and dry without moisture. It is not appropriate to construct it under adverse weather such as wet rain or snow. The working temperature should be between 0-40°C. Inadequate bonding.
Artificial turf paste production and construction of concrete steps are as follows:
First, glue adhesive:
It is required to use a brush to brush at the bottom of the lawn with a uniform coating thickness, and it must not be repeatedly coated. Otherwise, it will cause blistering or even drop. The thickness of the glue must be strictly controlled. Pay attention to the speed of glue application. Apply to the two bonded surfaces. on.
According to the temperature, humidity and other conditions at the time to reasonably control the open time, generally 10-15 minutes for a good plastic coating, glue to eighty-nine percent dry hand touch is not suitable. Bonding requires one-time alignment and adhesion. Do not move the bonded object back after bonding.
Second, pressure curing:
After bonding, the surface debris is removed, and a special rubber hammer is used to hammer from both sides of the joint firmly to make the surface fully bonded and solidified. The curing time is generally three days, and the final strength of the test is generally ten days. Therefore, it is necessary to pay close attention to its maintenance during curing, to avoid excessive explosion, water invasion and movement, in order to achieve the best bonding state.
Third, cutting rest:
After the bonding, the cut pieces of the site are cleaned before the quartz sand and the rubber particles are filled.
Fourth, paving quartz sand turf paste rest, you need to use grass seedlings with special quartz sand fixed grass seedlings, so that the grass seedlings are not lodging, sand irrigation to the grass seedlings remaining height within 10mm, spread grass seedlings on the surface of rubber particles, Sprinkle should be uniform, and sand grains should not be poured between grass seedlings to prevent athletes from being injured.
V. Inspection and acceptance After the above steps, the turf laying process is basically completed. Finally, the entire turf needs to be inspected and checked. If problems are found, they should be promptly reported and corrected.
Diamond Wire For Semiconductor Material Cutting
Diamond Wire for Semiconductor material cutting: diamond cutting wire is formed by uniformly consolidating diamond powder particles with a Mohs hardness of 10 on a high-strength steel wire substrate with a certain distribution density through a certain method. Originally used in sapphire cutting. Since 2010, diamond wire has been used in photovoltaic crystalline silicon wafer cutting, semiconductor material cutting, graphite cutting, jade cutting, magnetic material cutting, etc.
Diamond Wire For Semiconductor Material Cutting,Semiconductor Material Cutting,Semiconductor Material Cutting Wire,Diamond Wire For Semiconductor Material
Jiangyin Baoneng Precision New Material Co.,LTD , https://www.baonengwire.com