[China Aluminum Network] First check the aluminum saw blade fixing, transmission, safety device and the buttons are normal, and then according to the "squeeze production order" on the profile length, color, direction of loading cabinets, can not be mixed. Feed the sawing table until it hits a stop and straighten the profile. Spray a proper amount of cooling lubricating oil on the saw blade and begin sawing. When sawing, it is necessary to control the number of sawings at one time to prevent rubbing, and when sawing the finished blank and the light fabric, it is necessary to use a clean cloth for spacing between each branch.
The sawed section is loaded into the specified material frame, and the material with quality problems cannot be put into the frame. The heavy and heavy sections are installed below and the light and thin sections are installed on the top of the box. At the same time, it should be done gently to prevent crushing, embossing, and squeezing. Each layer of profile must be covered with bars, aluminum profiles of different lengths do not mix in principle, when mixed, it should be used to install the frame on the long and short, after the frame is installed with a color strip cover need to be timely Go to transit booth aging.
Plastic Optic Fiber Patch Cord
The plastic optic fiber Patch Cord is low attenuation, no heat, flexible, widely use in different purpose. We have different purpose and different function pacth cord. All of the products has CE, ROHS, Reach certificate. Our workshop area more 10000sqm, and we have professional R&D.
The patch cable connects with two connector. This is for different purpose, to [patch" a signal from one side, switch, or router to another side, switch, or router. Use patch cables to carry a variety of signals, such as: ethenet, telephone, and other industrial area.
fiber optic equipment,fiber optic patch cord,fiber patch cord
Jiangxi Daishing POF Co.,Ltd , https://www.opticfibrelight.com