The paste type wall surface refers to a wall surface that has been pasted with wallpaper, wall cloth, and the like.
>>> Link: TV is going to hang on the wall construction Please note
Paste wall type structure:
The wall is plastered with cement mortar to make the wall smooth. After drying, puttying and sanding with sandpaper, then paste the wallpaper with 107 glue or other adhesive.
Process flow:
Sweep grassroots, fill the gaps → Gypsum board joints at the joints, putty, matte paper → full scraping putty, rubbing → brushing moisture agent → brushing primer → wall surface line → wallpaper soaking → wallpaper, Grass-roots painting adhesive → wallpaper paper cutting, brushing → wall stickers, patchwork, lap joints, pairs of flowers → pressure adhesive bubbles → wipe glue → repair.
Construction points:
1. The grass-roots treatment must be cleaned, smooth, and smooth. The moisture-proof coating should be painted evenly and not too thick.
(1) Concrete and Plastering: The wall surface is cleaned and the surface cracks and pits are leveled with putty. Full of putty, polished flat. Determine the number of scraping passes as needed.
(2) Wood base layer: The wood base layer should be planed without burrs, flaws or exposed nail heads. Seams and nails are filled with putty. Full of putty, polished smooth.
(3) Gypsum board base: gypsum board joints are treated with caulking putty and fastened with joints. Putty on the surface. Brushing primer is generally used 107 glue, primer at once survived, but there can be no omission.
2. In order to prevent wallpaper and wall cloth from falling off, apply a layer of moisture-proof paint.
3. Play vertical and horizontal lines to ensure that wallpapers and wall coverings are horizontal and vertical with correct patterns.
4. When the plastic wallpaper meets the water, the glue will swell. Therefore, it is necessary to moisten the paper with water to fully inflate the plastic wallpaper. The wallpaper, wall covering, etc. of the glass fiber base material will not expand or contract with water, and the paper will not need to be moistened. Composite paper wallpaper and textile fiber wallpaper should not be stuffy.
5. After pasting, press the adhesive on the wallpaper to leave no bubbles, and the extruded glue should be cleaned in time.
Precautions:
1. Wall base moisture content should be less than 8%.
2. The flatness of the wall is checked with a 2-meter ruler, and the height difference does not exceed 2 mm.
3. When the patchwork is applied, the pattern and the back patchwork are matched so that the top and bottom patterns match.
4. It is forbidden to patch seams at the corners of the sun. The wallpaper must be wrapped over 20 mm above the sun's corner.
5. When glass fiber wall cloth and non-woven wall cloth are applied, the adhesive cannot be applied on the back, and the adhesive is brushed on the base layer. Because the wall cloth has small pores, the adhesive will print through the surface and appear glue marks, which will affect the appearance.
Wall construction wallpaper glass coating cement TV wallpaper craft glass
ABS Blade Ceiling Fan Without Light
Small Ceiling Fans Without Lights,Low Profile Ceiling Fan Without Light,Contemporary Ceiling Fans Without Lights,Flush Mount Ceiling Fan No Light
JIANGMEN ESCLIGHTING TECHNOLOGY LIMITED , https://www.jmwindfansummer.com